Your shopping cart is empty!
American Association of State and Highway Transportation Officials, 2016
Publisher: AASHTO
File Format: PDF
$44.00$89.00
Pages:14
File Size:1 file , 2.1 MB
Note:This product is unavailable in Ukraine, Russia, Belarus
This test method quantifies the tensile force needed to remove a pull-off stub adhered to a solid substrate with asphalt binder. Samples are prepared at controlled environmental and moisture conditions (i.e., temperature and humidity). After conditioning, a pneumatic load is applied to a pull-off stub using an ASTM D4541 Type IV adhesion tester until failure. The pull-off tensile strength and mode of failure are used to describe the bonding properties of the asphalt binder and compatibility between aggregates and asphalt binders.
This standard was formerly designated as provisional standard TP 91.
Standard Specification for Blended Hydraulic Cement
$25.00 $50.00
Standard Method of Test for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer (DSR)
$27.00 $55.00
Standard Method of Test for Bulk Density ("Unit Weight") and Voids in Aggregate (ASTM Designation: C29/C29M-07)
Standard Specification for Zinc Coating (Hot-Dip) on Iron and Steel Hardware (ASTM Designation: A 153/A 153M-09)
$30.00 $61.00
