• ASTM A182/A182M-12

ASTM A182/A182M-12

Standard Specification for Forged or Rolled Alloy and Stainless Steel Pipe Flanges, Forged Fittings, and Valves and Parts for High-Temperature Service

ASTM International, 05/15/2012

Publisher: ASTM

File Format: PDF

$28.00$56.40


Published:15/05/2012

Pages:16

File Size:1 file , 170 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

This specification covers forged low alloy and stainless steel piping components for use in pressure systems. Included are flanges, fittings, valves, and similar parts to specified dimensions or to dimensional standards, such as the ASME specifications that are referenced in Section 2.

For bars and products machined directly from bar (other than those directly addressed by this specification; see 6.4, refer to Specifications A479/A479M and A739 for the similar grades available in those specifications. Products made to this specification are limited to a maximum weight of 10,000 lb [4540 kg]. For larger products and products for other applications, refer to Specifications A336/A336M and A965/A965M for the similar ferritic and austenitic grades, respectively, available in those specifications.

1.3 Several grades of low alloy steels and ferritic, martensitic, austenitic, and ferritic-austenitic stainless steels are included in this specification. Selection will depend upon design and service requirements. Several of the ferritic/austenitic (duplex) grades are also found in Specification A1049/A1049M.

1.4 Supplementary requirements are provided for use when additional testing or inspection is desired. These shall apply only when specified individually by the purchaser in the order.

1.5 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable M specification designation (SI units), the material shall be furnished to inch-pound units.

1.6 The values stated in either SI units or inch-pound units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

More ASTM standard pdf

ASTM B319-91(2009)

ASTM B319-91(2009)

Standard Guide for Preparation of Lead and Lead Alloys for Electroplating

$26.00 $52.00

ASTM E2262-03(2009)

ASTM E2262-03(2009)

Standard Practice for Estimating Thurstonian Discriminal Distances

$45.00 $91.00

ASTM C652-00a

ASTM C652-00a

Standard Specification for Hollow Brick (Hollow Masonry Units Made From Clay or Shale)

$30.00 $60.00

ASTM D4501-01(2009)e1

ASTM D4501-01(2009)e1

Standard Test Method for Shear Strength of Adhesive Bonds Between Rigid Substrates by the Block-Shear Method

$30.00 $60.00