• Your shopping cart is empty!

  • ASTM A372/A372M-03(2008)

ASTM A372/A372M-03(2008)

Standard Specification for Carbon and Alloy Steel Forgings for Thin-Walled Pressure Vessels

ASTM International, 03/01/2008

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:01/03/2008

Pages:4

File Size:1 file , 78 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers relatively thin-walled forgings (including gas bottles) for pressure vessel use. Three types of carbon steel and six types of alloy steel are included. Provision is made for integrally forging the ends of vessel bodies made from seamless pipe or tubing.

Note 1 - When working to the chemical and tensile requirements of this specification, the influence of wall thickness and cooling rate will necessarily eliminate certain forging sizes in each class.

Note 2 - Designations have been changed as follows:

Current Formerly
Grade A Type I
Grade B Type II
Grade C Type III
Grade D Type IV
Grade E Class 55 Type V Grade 1 Class 55
Grade E Class 65 Type V Grade 1 Class 65
Grade E Class 70 Type V Grade 1 Class 70
Grade F Class 55 Type V Grade 2 Class 55
Grade F Class 65 Type V Grade 2 Class 65
Grade F Class 70 Type V Grade 2 Class 70
Grade G Class 55 Type V Grade 3 Class 55
Grade G Class 65 Type V Grade 3 Class 65
Grade G Class 70 Type V Grade 3 Class 70
Grade H Class 55 Type V Grade 4 Class 55
Grade H Class 65 Type V Grade 4 Class 65
Grade H Class 70 Type V Grade 4 Class 70
Grade J Class 55 Type V Grade 5 Class 55
Grade J Class 65 Type V Grade 5 Class 65
Grade J Class 70 Type V Grade 5 Class 70
Grade K Type VI
Grade L Type VII
Grade J Class 110 Type VIII
Grade M Class 85 Type IX Class A
Grade M Class 100 Type IX Class B

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 Unless the order specifies the applicable "M" specification designation (SI units), the material shall be furnished to inch-pound units.

More ASTM standard pdf

ASTM C1041-85(2001)

ASTM C1041-85(2001)

Standard Practice for In-Situ Measurements of Heat Flux in Industrial Thermal Insulation Using Heat Flux Transducers

$24.00 $48.00

ASTM D6904-03(2013)

ASTM D6904-03(2013)

Standard Practice for Resistance to Wind-Driven Rain for Exterior Coatings Applied on Masonry

$28.00 $56.00

ASTM E1302-00(2007)

ASTM E1302-00(2007)

Standard Guide for Acute Animal Toxicity Testing of Water-Miscible Metalworking Fluids

$29.00 $58.00

ASTM D3368-99

ASTM D3368-99

Standard Specification for FEP-Fluorocarbon Resin Sheet and Film

$29.00 $58.00