ASTM A381-96(2012)

Standard Specification for Metal-Arc-Welded Steel Pipe for Use With High-Pressure Transmission Systems

ASTM International, 03/01/2012

Publisher: ASTM

File Format: PDF

$30.00$60.00

Description

Published:01/03/2012

Pages:5

File Size:1 file , 98 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers straight seam, double-submerged-arc-welded steel pipe (Note 1) suitable for high-pressure service, 16 in. (406 mm) and larger in outside diameter, with wall thicknesses from ⁵/₁₆ to 1¹/₂ in. (7.9 to 38 mm). The pipe is intended for fabrication of fittings and accessories for compressor or pump-station piping. Pipe ordered to this specification shall be suitable for bending, flanging (vastoning), corrugating, and similar operations.

Note 1???A comprehensive listing of standardized pipe dimensions is contained in ANSI B36.10 .

Note 2???The term ???double welded??? is commonly used in the gas and oil transmission industry, for which this pipe is primarily intended, to indicate welding with at least two weld passes, of which one is on the outside of the pipe and one on the inside. For some sizes of the pipe covered by this specification, it becomes expedient to use manual welding, in which case the provisions of Note 3 shall be followed.

1.2 Nine classes of pipe, based on minimum yield point requirements, are covered as indicated in Table 1.

TABLE 1 Tensile Requirements

Class	Yield Strength, min, psi (MPa)	Tensile Strength, min, psi (MPa)	Elongation in 2 in. (50.8 mm), min, %
Y 35	35 000 (240)	60 000 (415)	26
Y 42	42 000 (290)	60 000 (415)	25
Y 46	46 000 (316)	63 000 (435)	23
Y 48	48 000 (330)	62 000 (430)	21
Y 50	50 000 (345)	64 000 (440)	21
Y 52	52 000 (360)	66 000 (455)	20
Y 56	56 000 (385)	71 000 (490)	20
Y 60	60 000 (415)	75 000 (515)	20
Y 65	65 000 (450)	77 000 (535)	20

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following caveat applies to the test methods portion, Sections 9 and 10, only. This standard does not purport to address all of the safety concerns, if any,

More ASTM standard pdf

ASTM D7500-15(2019)

Standard Test Method for Determination of Boiling Range Distribution of Distillates and Lubricating Base Oils-in Boiling Range from 100 oC to 735 oC by Gas Chromatography

$28.00 $56.00

ASTM D5391-99(2009)

Standard Test Method for Electrical Conductivity and Resistivity of a Flowing High Purity Water Sample

$30.00 $60.00

ASTM A640-97(2009)e1

Standard Specification for Zinc-Coated Steel Strand for Messenger Support of Figure 8 Cable

$26.00 $52.00

ASTM D6365-99(2018)

Standard Practice for Nondestructive Testing of Geomembrane Seams Using the Spark Test

$21.00 $42.00