Your shopping cart is empty!
ASTM International, 11/01/2012
Publisher: ASTM
File Format: PDF
$33.00$67.00
Published:01/11/2012
Pages:17
File Size:1 file , 350 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification2 covers a group of common requirements that, unless otherwise specified in an individual specification, shall apply to steel castings for pressure-containing parts under each of the following ASTM specifications:
Title of Specification
ASTM Designation
Steel Castings, Carbon, Suitable for Fusion Welding,
A216/A216M
for High-Temperature Service
Steel Castings, Martensitic Stainless and Alloy, for
A217/A217M
Pressure-Containing Parts, Suitable for High-
Temperature Service
Castings, Austenitic, Austenitic-Ferritic (Duplex),
A351/A351M
Pressure-Containing Parts
Steel Castings, Ferritic and Martensitic, for Pressure-
A352/A352M
Containing Parts, Suitable for Low-Temperature
Service
Steel Castings, Alloy, Specially Heat-Treated, for
A389/A389M
Steel Castings Suitable for Pressure Service
A487/A487M
Castings, Iron-Nickel-Chromium and Nickel Alloys, Specially Controlled for Pressure Retaining Parts for Corrosive Service
A990
Castings, Austenitic-Ferritic (Duplex) Stainless Steel, for Pressure-Containing Parts
A995/A995M
1.2 This specification also covers a group of supplementary requirements which may be applied to the above specifications as indicated therein. These are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.
1.3 In case of conflict between the requirements of the individual specification and this general specification, the former shall prevail.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Standard Test Method for Measuring Relative Movement Capabilities of Through-Penetration Firestop Systems
$33.00 $67.00
Standard Specification for Vacuum-Treated Carbon and Alloy Steel Forgings for Turbine Rotors and Shafts
$25.00 $50.00
Standard Specification for Lathing and Furring Accessories, and Fasteners, for Interior and Exterior Portland Cement-Based Plaster
$36.00 $72.00
Standard Specification for Commercial Steel (CS), Sheet, Carbon (0.16;% Maximum to 0.25 % Maximum), Cold-Rolled
