Your shopping cart is empty!
ASTM International, 09/01/2012
Publisher: ASTM
File Format: PDF
$33.00$67.00
Published:01/09/2012
Pages:12
File Size:1 file , 230 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers a group of common requirements that are mandatory for steel castings produced by the investment casting process for pressure-containing parts under each of the following ASTM Specifications:
Title of Specification
ASTM Designation
Steel Castings, Carbon, Suitable for Fusion Welding,
A216/A216M
for High-Temperature Service
Steel Castings, Martensitic Stainless and Alloy, for
A217/A217M
Pressure-Containing Parts, Suitable for High-
Temperature Service
Castings, Austenitic, Austenitic-Ferritic (Duplex),
A351/A351M
for Pressure-Containing Parts
Steel Castings, Ferritic and Martensitic, for Pressure-
A352/A352M
Containing Parts, Suitable for Low-Temperature
Service
Steel Castings, Alloy, Specially Heat-Treated, for
A389/A389M
Steel Castings Suitable for Pressure Service
A487/A487M
Castings, Iron-Nickel-Chromium and Nickel Alloys, Specially Controlled for Pressure Retaining Parts for Corrosive Service
A990
Castings, Austenitic-Ferritic (Duplex) Stainless Steel, for Pressure-Containing Parts
A995/A995M
1.2 This specification also covers a group of supplementary requirements, which may be applied to the above specifications as indicated therein. These requirements are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.
1.3 When investment casting is ordered, the requirements of this specification shall take precedence over the individual material specification requirements.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Guide for Editorial Procedures and Form of Product Specifications for Copper and Copper Alloys
$32.00 $65.00
Standard Practice for Measuring and Calculating Building Loss Features That Take Up Floor Area in Buildings
Standard Test Method for Determining Molecular Weight Distribution and Molecular Weight Averages of Polyolefins by High Temperature Gel Permeation Chromatography
$30.00 $60.00
Standard Test Method for Particle Size Distribution of Granular Activated Carbon
$34.00 $68.00
