ASTM B160-05e1

Standard Specification for Nickel Rod and Bar

ASTM International, 05/01/2005

Publisher: ASTM

File Format: PDF

$30.00$60.00

Description

Published:01/05/2005

Pages:6

File Size:1 file , 96 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers nickel (UNS N02200)*, low carbon nickel (UNS N02201)*, and solution strengthened nickel (UNS N02211) in the form of hot-worked and cold-worked rod and bar in the conditions shown in Table 1.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

TABLE 1 Mechanical Properties

Condition and Diameter or Distance Between Parallel Surfaces, in. (mm)	Tensile Strength, min, psi (MPa)	Yield Strength (0.2 % offset), min. psi (MPa)^A	Elongation in 2 in. or 50 mm or 4D, min %
Nickel (UNS N02200)
Cold-worked (as worked):
Rounds, 1 (25.4) and under	80 000 (550)	60 000 (415)	10^B
Rounds over 1 to 4 (25.4 to 101.6) incl.	75 000 (515)	50 000 (345)	15
Squares, hexagons, and rectangles, all sizes	65 000 (450)	40 000 (275)	25^B
Hot-worked:
All sections, all sizes	60 000 (415)	15 000 (105)	35^C
Rings and disks^D	-	-	-
Annealed:
Rods and bars, all sizes	55 000 (380)	15 000 (105)	40^B
Rings and disks^E	-	-	-
Forging quality
All sizes	^F	^F	^F
Low-Carbon Nickel (UNS N02201) and Solution Strengthened Nickel (UNS N02211)
Hot-worked:
All sections, all sizes	50 000 (345)	10 000 (70)	40^C
Annealed:
All products, all sizes	50 000 (345)	10 000 (70)	40^B

^A See 12.2.

^B Not applicable to diameters or cross sections under ³/₃₂ in. (2.4 mm).

^C For hot-worked flats ⁵/₁₆ in. (7.9 mm) and under in thickness the elongation shall be 25%, min.

^D Hardness B45 to B80, or equivalent.

^E Hardness B45 to B70 or equivalent.

^F Forging quality is furnished to chemical requirements and surface inspection only. No tensile properties are required.

More ASTM standard pdf

ASTM D1424-09(2013)

Standard Test Method for Tearing Strength of Fabrics by Falling-Pendulum (Elmendorf-Type) Apparatus

$30.00 $60.00

ASTM E2495-13

Standard Practice for Prioritizing Asset Resources in Acquisition, Utilization, and Disposition

$29.00 $58.00

ASTM D5390-93(2013)

Standard Test Method for Open-Channel Flow Measurement of Water with Palmer-Bowlus Flumes

$32.00 $64.00

ASTM D4157-13

Standard Test Method for Abrasion Resistance of Textile Fabrics (Oscillatory Cylinder Method)

$30.00 $60.00