Your shopping cart is empty!
ASTM International, 10/10/1998
Publisher: ASTM
File Format: PDF
$25.00$50.00
Published:10/10/1998
Pages:3
File Size:1 file , 35 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers alloys UNS N06002, UNS N06230, UNS N12160, and UNS R30556* in the form of rod for heat resisting and general-corrosive service.
1.2 The following products are covered under this specification:
1.2.1 Rods 5/16 to 3/4 in. (7.94 to 19.05 mm) exclusive in diameter, hot or cold finished, solution-annealed, and pickled or mechanically descaled.
1.2.2 Rods 3/4 to 3 1/2 in. (19.05 to 88.9 mm) inclusive in diameter, hot or cold finished, solution annealed, ground, or turned.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
Standard Test Method for Measuring Heat Transfer Rate Using a Thin-Skin Calorimeter
$31.00 $63.00
Standard Test Method for Dropping Point of Lubricating Grease Over Wide Temperature Range
$27.00 $54.00
Standard Practice for Sectional Repair of Existing Gravity Flow, Non-Pressure Pipelines and Conduits by Pushed or Pulled-In-Place Installation of Cured-In-Place Thermosetting Resin Pipe (CIPP)
Standard Specification for Installation of Lathing and Furring to Receive Interior and Exterior Portland Cement-Based Plaster
$34.00 $68.00
