Your shopping cart is empty!
ASTM International, 06/01/2015
Publisher: ASTM
File Format: PDF
$25.00$50.00
Published:01/06/2015
Pages:3
File Size:1 file , 79 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers certain zinc-aluminum (Zn-Al) alloys in ingot form for re-melting for use in the production of hot-dip coatings on steel. Alloy compositions are specified below and in Table 1.
ASTM
Common
UNS
Type 5
95/5 Zn/Al
to be assigned
Type 10
90/10 Zn/Al
Type 15
85/15 Zn/Al
Note 1: The zinc-aluminum alloys in Specification B997 are intended to be used primarily to create a molten zinc-aluminum bath and differ from the master alloys in Specification B860 which are intended primarily to adjust the concentration of certain elements in molten zinc galvanizing baths.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Methods for Determination of Gold in Bullion by Cupellation
$29.00 $58.00
Standard Practice for Visual Signals Between Persons on the Ground and in Aircraft During Ground Emergencies
$25.00 $50.00
Standard Specification for Steel, Sheet, Carbon, Structural, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for
$44.00 $89.00
Standard Guide for Assessment of Surface Texture of Non-Porous Biomaterials in Two Dimensions
