• Your shopping cart is empty!

  • ASTM C1214M-13

ASTM C1214M-13

Standard Test Method for Concrete Pipe Sewerlines by Negative Air Pressure (Vacuum) Test Method (Metric)

ASTM International, 07/01/2013

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:01/07/2013

Pages:4

File Size:1 file , 70 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers procedures for testing concrete pipe sewerlines, when using the negative air pressure (vacuum) test method to demonstrate the integrity of the installed material and the construction procedures. This test method covers testing of 100 to 900-mm diameter circular concrete pipe sewerlines utilizing gasketed joints.

Note 1-The user of this specification is advised that methods described in this test method may also be used as a preliminary test to enable the manufacturer or installer to demonstrate the condition of sewer pipe prior to delivery or backfill. Minimum test times presented in Table 1 are for pipelines. Holding times for testing an individual pipe may have to be increased to allow for the accumulation of leakage when the tested pipe are incorporated into a continuous pipeline.
Note 2-The user of this test method is advised that the negative air pressure (vacuum) test criteria presented in this test method are similar to those in general use. The test and criteria have been used widely and successfully in testing smaller diameter pipe. Larger pipe will be accepted more conveniently by visual inspection and individual joint testing.
Note 3-Test times tabulated and the rate of air loss in this standard are based on successful testing of installed pipelines. However, since air and water have different physical properties, retests of some pipelines not meeting field air tests have been successful when tested with water.

1.2 This test method is the SI companion to Test Method C1214.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 6 for specific safety precautions.

More ASTM standard pdf

ASTM D6121-06a

ASTM D6121-06a

Standard Test Method for Evaluation of Load-Carrying Capacity of Lubricants Under Conditions of Low Speed and High Torque Used for Final Hypoid Drive Axles

$33.00 $67.00

ASTM A964/A964M-17

ASTM A964/A964M-17

Standard Specification for Corrugated Steel Box Culverts

$38.00 $76.00

ASTM E2899-19

ASTM E2899-19

Standard Test Method for Measurement of Initiation Toughness in Surface Cracks Under Tension and Bending

$43.00 $86.00

ASTM D7261-07

ASTM D7261-07

Standard Test Method for Determining Water Separation Characteristics of Diesel Fuels by Portable Separometer

$30.00 $60.00