• Your shopping cart is empty!

  • ASTM D1238-23

ASTM D1238-23

Standard Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer

ASTM International, 02/01/2023

Publisher: ASTM

File Format: PDF

$31.00$63.00


Published:01/02/2023

Pages:19

File Size:1 file , 430 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of the rate of extrusion of molten thermoplastic resins using an extrusion plastometer.
1.2 The values stated in SI units are to be regarded as standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: This standard and ISO 1133 address the same subject matter, but differ in technical content.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D6747-04

ASTM D6747-04

Standard Guide for Selection of Techniques for Electrical Detection of Potential Leak Paths in Geomembrane

$30.00 $60.00

ASTM G193-11a

ASTM G193-11a

Standard Terminology and Acronyms Relating to Corrosion

$32.00 $65.00

ASTM D3532/D3532M-12

ASTM D3532/D3532M-12

Standard Test Method for Gel Time of Carbon Fiber-Epoxy Prepreg

$26.00 $52.00

ASTM D3846-94

ASTM D3846-94

Standard Test Method for In-Plane Shear Strength of Reinforced Plastics

$25.00 $50.00