Your shopping cart is empty!
ASTM International, 01/01/2020
Publisher: ASTM
File Format: PDF
$22.00$44.00
Published:01/01/2020
Pages:4
File Size:1 file , 87 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover procedures for testing adhesives in liquid, highly viscous, solid, or set states, that are intended to be cured by electronic heating, or that are intended to provide electrical insulation, or that are intended for use in electrical apparatus.
1.2 The procedures appear in the following order:
(1) Procedure for Testing Adhesives Before Use:
Section
Power Factor and Dielectric Constant of Liquid Adhesives
7
Direct-Current Conductivity
8
Extract Conductivity
9
Acidity and Alkalinity
10
pH Value
11
(2) Procedures for Testing Properties of Adhesives As Used:
Power Factor and Dielectric Constant of a Dried or Cured Adhesive Film
12
Dielectric Strength
13
Volume and Surface Resistivity
14
Arc Resistance
15
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 8.2.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Methods for Sealability of Gasket Materials
$29.00 $58.00
Standard Specification for Polyolefin-Based Plastic Lumber Decking Boards
$33.00 $67.00
Standard Practice for Blowout Resistance of Room-Temperature Vulcanized Elastomers
Standard Guide for Preparing and Interpreting Precision and Bias Statements in Test Method Standards Used in the Nuclear Industry
$20.00 $40.00
