• Your shopping cart is empty!

  • ASTM D1388-23

ASTM D1388-23

Standard Test Method for Stiffness of Fabrics

ASTM International, 08/01/2023

Publisher: ASTM

File Format: PDF

$28.00$57.00


Published:01/08/2023

Pages:8

File Size:1 file , 470 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the measurement of stiffness properties of fabrics. Bending length is measured and flexural rigidity is calculated. Two procedures are provided.
1.1.1 Option A-Cantilever Test, employing the principle of cantilever bending of the fabric under its own mass.
1.1.2 Option B-Heart Loop Test, employing the principle of a loop formed in a fabric strip and hung vertically.
1.2 This test method applies to most fabrics including woven fabrics, air bag fabrics, blankets, napped fabrics, knitted fabrics, layered fabrics, pile fabrics. The fabrics may be untreated, heavily sized, coated, resin-treated, or otherwise treated.
1.2.1 This method may be used to determine the stiffness of nonwoven materials (for example, hydroentangled, dry laid, needlepunch, resin bonded, thermal, and wet laid) or refer to Test Method D5732. To determine the stiffness of medical textiles (for example, surgical mesh, films, and membranes), refer to Test Method F3260.
Note 1: The formula to calculate flexural rigidity in D5732-95 (2001) is incorrect and should not be used. Utilize the formula presented in 11.5 of Test Method D1388.
1.3 Units-The values stated in SI units are to be regarded as the standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM E2336-16

ASTM E2336-16

Standard Test Methods for Fire Resistive Grease Duct Enclosure Systems

$33.00 $67.00

ASTM D1122-13

ASTM D1122-13

Standard Test Method for Density or Relative Density of Engine Coolant Concentrates and Engine Coolants By The Hydrometer

$26.00 $52.00

ASTM D7320-16

ASTM D7320-16

Standard Test Method for Evaluation of Automotive Engine Oils in the Sequence IIIG, Spark-Ignition Engine

$45.00 $91.00

ASTM C90-05a

ASTM C90-05a

Standard Specification for Loadbearing Concrete Masonry Units

$26.00 $52.00