Your shopping cart is empty!
ASTM International, 08/01/2017
Publisher: ASTM
File Format: PDF
$36.00$72.00
Published:01/08/2017
Pages:11
File Size:1 file , 570 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover procedures for measuring the performance of finish flooring under the following service loadings and conditions:
Section
Loading Tests
Concentrated Loading
7
Floor Surface Indentation from Small Area Loads
12
Falling-Ball Indentation
18
Rolling Load
23
Mechanical Tests
Abrasion Resistance
28
Coefficient of Friction
33
Moisture Tests
Surface Wetting
38
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Retention Characteristics of 0.2-mu m Membrane Filters Used in Routine Filtration Procedures for the Evaluation of Microbiological Water Quality
$26.00 $52.00
Standard Test Method for Determining Visible Abrasion Resistance of Glazed Ceramic Tile
$30.00 $60.00
Standard Method Of Test For Flash Point By Tag Closed Tester
$24.00 $49.20
Standard Specification for High-Strength Low-Alloy Steel Shapes of Structural Quality, Produced by Quenching and Self-Tempering Process (QST)
