ASTM D3381/D3381M-13

Standard Specification for Viscosity-Graded Asphalt Cement for Use in Pavement Construction

ASTM International, 06/01/2013

Publisher: ASTM

File Format: PDF

$26.00$52.00

Description

Published:01/06/2013

Pages:3

File Size:1 file , 74 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers asphalt cements graded by viscosity at 60°C [140°F] for use in pavement construction. Four sets of limits are offered in this specification. The purchaser shall specify the applicable table of limits. In the event the purchaser does not specify limits, Table 1 shall apply. For asphalt cements graded by penetration at 25°C [77°F]. See Specification D946. If needed, volume corrections for asphalt cements should be made according to Practice D4311.

TABLE 1 Requirements for Asphalt Cement, Viscosity Graded at 60°C [140°F] Based on Original Asphalt

Test	Viscosity Grade
Test	AC-2.5	AC-5	AC-10	AC-20	AC-30	AC-40
Viscosity, 60°C [140°F], Pa·s	25 ± 5	50 ± 10	100 ± 20	200 ± 40	300 ± 60	400 ± 80
Viscosity, 135°C [275°F], min, mm²/s	80	110	150	210	250	300
Penetration, 25°C [77°F], 100 g, 5 s, min	200	120	70	40	30	20
Flash point, Cleveland open cup, min,°C [°F]	165 [325]	175 [350]	220 [425]	230 [450]	230 [450]	230 [450]
Solubility in trichloroethylene,^A min, %	99.0	99.0	99.0	99.0	99.0	99.0
Tests on residue from thin-film oven test:
Viscosity, 60°C [140°F], max, Pa·s	125	250	500	1000	1500	2000
Ductility, 25°C [77°F], 5 cm/min, min, cm	100^B	100	50	20	15	10

^A Solubility in N-Propyl Bromide can be an alternate method to Solubility in TCE.

^B If ductility is less than 100, material will be accepted if ductility at 15°C [60°F] is 100 minimum at a pull rate of 5 cm/min.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

More ASTM standard pdf

ASTM D5291-10(2015)

ASTM D5291-10(2015)

Standard Test Methods for Instrumental Determination of Carbon, Hydrogen, and Nitrogen in Petroleum Products and Lubricants

$30.00 $60.00

ASTM E605-93(2000)

ASTM E605-93(2000)

Standard Test Methods for Thickness and Density of Sprayed Fire-Resistive Material (SFRM) Applied to Structural Members

$29.00 $58.00

ASTM D3705-14

Standard Test Method for Misting Properties of Lubricating Fluids

$30.00 $60.00

ASTM C1033-85(2000)

ASTM C1033-85(2000)

Standard Test Method for Steady-State Heat Transfer Properties of Pipe Insulation Installed Vertically (Withdrawn 2003)

$30.00 $60.00