Your shopping cart is empty!
ASTM International, 09/01/2006
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/09/2006
Pages:9
File Size:1 file , 170 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the determination of puncture properties of plastics, including films, over a range of test velocities.
1.2 Test data obtained by this test method is relevant and appropriate for use in engineering design.
1.3 The values stated in SI units are to be regarded as standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
This specification does not closely conform to ISO 6603.2. The only similarity between the two tests is that they are both instrumented impact tests. The differences in striker, fixture, and specimen geometries and in test velocity can produce significantly different test results.
Standard Specification for Thin Veneer Brick Units Made From Clay or Shale
$25.00 $50.00
Standard Test Method for Measurement of Interstitial Oxygen Content of Silicon Wafers by Infrared Absorption Spectroscopy with p-Polarized Radiation Incident at the Brewster Angle
$29.00 $58.00
Standard Test Method for Measuring Friction and Wear Properties of Lubricating Grease Using a High-Frequency, Linear-Oscillation (SRV) Test Machine
$30.00 $60.00
Standard Specification for Ferrotungsten
$26.00 $52.00