Your shopping cart is empty!
ASTM International, 08/01/2014
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/08/2014
Pages:6
File Size:1 file , 150 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This standard classification system and basis for specification covers polytetrafluoroethylene (PTFE) filled molding compounds made with virgin PTFE resins defined in Specification D4894, as Types II and III.
Note 1: This system can be used as a model for other PTFE compounds having particulate fillers that can survive the sintering temperatures of PTFE as can those listed in this standard. This system is restricted to virgin PTFE base resin for technical reasons. Recycled or reprocessed material cannot be processed successfully.
Note 2: The properties measured on commercially fabricated parts may differ from the listed values for samples prepared by the procedures given in this specification, depending on part geometry and processing parameters.
1.2 The values stated in SI units are to be regarded as standard.
1.3 The following statement applies to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Note 5 for a specific warning statement.
Note 3: There is no known ISO equivalent to this standard.
Standard Specification for Hot Isostatically-Pressed Alloy Steel Flanges, Fittings, Valves, and Parts for High Temperature Service
$29.00 $58.00
Standard Specification for Structural Steel with Low Yield to Tensile Ratio for Use in Buildings
$26.00 $52.00
Standard Specification for Liquid Applied Acrylic Coating Used in Roofing
Standard Test Method for Specific Heat of Liquids and Solids (Withdrawn 2018)
$30.00 $60.00
