• Your shopping cart is empty!

  • ASTM D5324-16(2022)

ASTM D5324-16(2022)

Standard Guide for Testing Water-Borne Architectural Coatings

ASTM International, 12/01/2022

Publisher: ASTM

File Format: PDF

$31.00$63.00


Published:01/12/2022

Pages:12

File Size:1 file , 230 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This guide covers the selection and use of procedures for testing water-borne coatings to be used on exterior, interior or both types of surfaces (Note 1). The properties that can be examined or, in some cases, the relevant test procedures are listed in Table 1 and Table 2.
Note 1: The term "architectural coating" as used here combines the definition in Terminology D16 with that in the FSCT Paint/Coatings Dictionary, 2 as follows: "Organic coatings intended for on-site application to interior or exterior surfaces of residential, commercial, institutional, or industrial buildings, in contrast to industrial coatings. They are protective and decorative finishes applied at ambient temperatures. Often called Trade Sales Coatings."
Note 2: Architectural coatings that are designed to give better performance than most conventional coatings because they are tougher and more stain and abrasion resistant are covered by Guide D3730.
1.2 The types of organic coatings covered by this guide are as follows:
(1) Type 1 Interior Latex Flat Wall Paints, (2) Type 2 Exterior Latex House Paints, (3) Type 3 Water-Borne Floor Paints, and (4) Type 4 Interior Latex Semigloss and Gloss Paints.
1.2.1 Each is intended for application by brushing, rolling, spraying or other means to the material appropriate for its type, which may include plaster, masonry, wallboard, wood, steel, previously painted surfaces, and other architectural substrates.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D4781-99

ASTM D4781-99

Standard Test Method for Mechanically Tapped Packing Density of Fine Catalyst Particles and Catalyst Carrier Particles

$25.00 $50.00

ASTM D2810-72(1996)

ASTM D2810-72(1996)

Standard Test Method for pH of Leather

$25.00 $50.00

ASTM C361-05e1

ASTM C361-05e1

Standard Specification for Reinforced Concrete Low-Head Pressure Pipe

$33.00 $67.00

ASTM D8071-17

ASTM D8071-17

Standard Test Method for Determination of Hydrocarbon Group Types and Select Hydrocarbon and Oxygenate Compounds in Automotive Spark-Ignition Engine Fuel Using Gas Chromatography with Vacuum Ultraviolet Absorption Spectroscopy Detection (GC-VUV)

$32.00 $65.00