ASTM D5579-19e1

1.1''This test method covers the thermal stability of fluids for use in heavy duty manual transmissions when operated at high temperatures.

1.2''The lubricant performance is measured by the number of shifting cycles that can be performed without failure of synchronization when the transmission is operated while continuously cycling between high and low range.

1.3''Correlation of test results with truck transmission service has not been established. However, the procedure has been shown to appropriately separate two transmission lubricants, which have shown satisfactory and unsatisfactory field performance in the trucks of one manufacturer.

1.4''Changes in this test method may be necessary due to refinements in the procedure, obsolescence of parts, or reagents, and so forth. These changes will be incorporated by Information Letters issued by the ASTM Test Monitoring Center (TMC). The test method will be revised to show the content of all the letters, as issued.

1.5''The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7''This test method is arranged as follows:

''	Section
Scope	'''1
Referenced Documents	'''2
Terminology	'''3
Summary of Test Method	'''4
Significance and Use	'''5
Apparatus	'''6
'''Test Transmission	'''6.2
'''Transmission Mounts	'''6.3
'''Oil-Circulating System	'''6.4
'''Oil Return Hole	'''6.5
'''Air Pressure Controls	'''6.6
'''Drive System	'''6.7
'''Instrumentation	'''6.8
'''Thermocouple Placement	'''6.9
Reagents and Materials	'''7
Safety	'''8
Preparation of Apparatus	'''9
'''Cleaning of Parts	'''9.1
'''Assembly	'''9.2
Calibration	'''10
'''Transmission and Test Stand Calibration	'''10.1
'''Reference Oils	'''10.2
'''Reference Oil Test Frequency	'''10.3
'''Instrumentation Calibration	'''10.4
'''Shift Time Calibration	'''10.5
Operating Procedure	More ASTM standard pdf ASTM D6243-98 Standard Test Method for Determining the Internal and Interface Shear Resistance of Geosynthetic Clay Liner by the Direct Shear Method $29.00 $58.00 Add to Cart ASTM DS 4B Physical Constants of Hydrocarbon and Non-Hydrocarbon Compounds $142.00 $284.21 Add to Cart ASTM F1515-98 Standard Test Method for Measuring Light Stability of Resilient Vinyl Flooring by Color Change $25.00 $50.00 Add to Cart ASTM D1223-93(1998) Standard Test Method for Specular Gloss of Paper and Paperboard at 75 degrees $29.00 $58.00 Add to Cart