Your shopping cart is empty!
ASTM International, 07/01/2007
Publisher: ASTM
File Format: PDF
$27.00$54.00
Published:01/07/2007
Pages:3
File Size:1 file , 67 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method determines the effect of constant cyclic displacement on polymer-modified bituminous membrane specimens. In this test method, a relatively low travel rate of cycling is used and the material is tested for a specified number of cycles under conditions of increased amplitude or lower temperature.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Practice for Load Handling When Using an Exoskeleton
$36.00 $72.00
Standard Practice for Measuring Fluidization Segregation Tendencies of Powders
$24.00 $48.00
Standard Test Method for Determination of Frictional Torque and Friction Factor for Hip Implants Using an Anatomical Motion Hip Simulator
$26.00 $52.00
Standard Test Method for Compressive Properties of Plastic Lumber and Shapes
