• ASTM D5874-02(2007)

ASTM D5874-02(2007)

Standard Test Method for Determination of the Impact Value (IV) of a Soil

ASTM International, 05/01/2007

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/05/2007

Pages:9

File Size:1 file , 170 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of the Impact Value (IV) of a soil either in the field or a test mold.

1.2 The standard test method, using a 4.5 kg (10 lbm) hammer, is suitable for, but not limited to, evaluating the strength of an unsaturated compacted fill, in particular pavement materials, soils, and soil-aggregates having maximum particle sizes less than 37.5 mm (1.5 in.).

1.3 By using a lighter 0.5 kg (1.1 lbm) hammer, this test method is applicable for evaluating lower strength soils such as fine grained cohesion less, highly organic, saturated, or highly plastic soils having a maximum particle size less than 9.5 mm (0.375 in.).

1.4 By performing laboratory test correlations for a particular soil using the 4.5 kg (10 lbm) hammer, IV may be correlated with an unsoaked California Bearing Ratio (CBR) or may be used to infer percentage compaction.

1.5 The values stated SI are to be regarded as the standard. The values stated in parentheses are given for information only.

1.6 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026. The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses or both. How one applies the results obtained using this standard is beyond its scope.

1.7 This standard may involve hazardous materials, operations, and equipment This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1The equipment and procedures contained in this test method are similar to those developed by B. Clegg in the 1970s at the University of Western Australia, Nedlands, Australia. Impact Value is also commonly known as Clegg Impact Value (CIV).

More ASTM standard pdf

ASTM G214-16

ASTM G214-16

Standard Test Method for Integration of Digital Spectral Data for Weathering and Durability Applications

$34.00 $68.00

ASTM E2758-15a

ASTM E2758-15a

Standard Guide for Selection and Use of Wideband, Low Temperature Infrared Thermometers

$34.00 $69.00

ASTM D3574-03

ASTM D3574-03

Standard Test Methods for Flexible Cellular Materials - ;Slab, Bonded, and Molded Urethane Foams

$43.00 $86.00

ASTM E1852-96e1

ASTM E1852-96e1

Standard Test Method for Determination of Low Levels of Antimony in Carbon and Low-Alloy Steel by Electrothermal Atomic Absorption Spectrometry

$25.00 $50.00