Your shopping cart is empty!
ASTM International, 05/01/2013
Publisher: ASTM
File Format: PDF
$36.00$72.00
Published:01/05/2013
Pages:19
File Size:1 file , 310 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This engine lubricant test method is commonly referred to as the Roller Follower Wear Test. Its primary result, roller follower shaft wear in the hydraulic valve lifter assembly, has been correlated with vehicles used in stop-and-go delivery service prior to 1993. It is one of the test methods required to evaluate lubricants intended to satisfy the API CG-4 performance category. This test has also been referred to as the 6.2 L Test.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1 Exceptions-Where there is no direct SI equivalent, such as pipe fittings, thermocouple diameters, and NPT screw threads. Also, roller follower wear is measured in mils.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 Table of Contents:
Section
Scope
1
Referenced Documents
2
Terminology
3
Summary of Test Method
4
Significance and Use
5
Reagents
7
Guidelines on Substitution
7.1
Apparatus
6
Preparation of Apparatus
8
New Engine Preparation
8.1
Installation of Auxiliary Systems and Miscellaneous Components
8.2
Test Procedure
9
Description of Test Segments and Organization of Test Procedure Sections
9.1
Engine Parts Replacement
9.2
Engine Starting Procedure
9.3
Normal Engine Shutdown Procedure
9.4
Emergency Shutdown Procedure
9.5
Unscheduled Shutdown and Downtime
9.6
New Engine Break-In
9.7
Pretest Procedure
9.8
Fifty-Hour Steady State Test
9.9
Periodic Measurements
9.10
Oil Sampling and Oil Addition Procedures
9.11
End of Test (EOT) Procedure
9.12
Calculation and Interpretation of Test Results
10
Environment of Parts Measurement Area
10.1
Roller Follower Shaft Wear Measurements
10.2
Oil Analysis
10.3
Assessment of Test Validity
10.4
Final Test Report
Safety in Baseball/Softball
$119.00 $238.40
Standard Practice for Atmospheric Leaks Using a Thermal Conductivity Leak Detector
$21.00 $42.00
Standard Test Methods for Detecting Susceptibility to Intergranular Corrosion in Wrought, Nickel-Rich, Chromium-Bearing Alloys
$28.00 $57.00
Standard Specification for Molybdenum Wire and Rod for Electronic Applications
$27.00 $54.00
