Your shopping cart is empty!
ASTM International, 06/01/2013
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/06/2013
Pages:7
File Size:1 file , 100 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover the evaluation of fastener use with “as manufactured” plastic lumber and shapes through the use of two different testing procedures.
1.2 The test methods appear in the following order:
Sections
Test Method A-Nail, Staple, or Screw Withdrawal Test
4 to 13
Test Method B-Lateral Nail, Staple, or Screw Resistance Test
14 to 22
1.3 Plastic lumber and plastic shapes are currently made predominately from recycled plastics. However, these test methods would also be applicable to similar manufactured plastic products made from virgin resins where the product is non-homogeneous in the cross-section.
1.4 The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Determining the Fracture Properties of Asphalt Binder in Direct Tension (DT) (Withdrawn 2021)
$34.00 $69.00
Standard Test Method for Linear Thermal Expansion of Electrode Carbons
$32.00 $64.00
Standard Specification for Expansive Hydraulic Cement
$23.00 $46.00
Standard Practice for Heat and Humidity Aging of Oxidatively Degradable Plastics
$24.00 $48.00
