Your shopping cart is empty!
ASTM International, 05/01/2013
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/05/2013
Pages:6
File Size:1 file , 110 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification is intended to be a means of calling out plastic product used in the fabrication of end items or parts.
1.2 This specification covers requirements and test methods for the material, dimensions, and workmanship, and the properties of extruded- and compression-molded rod, and heavy-walled tube manufactured from granular unfilled PTFE resin in accordance with Specification D4894.
1.3 This specification covers rod and heavy-walled tubing made wholly from polytetrafluoroethylene and produced in accordance with good commercial practice.
1.4 The properties included in this specification are those required for the compositions covered. Requirements necessary to identify particular characteristics important to specialized applications are described by using the classification system given in Section 4.
1.5 This specification allows for the use of recycled plastics as defined in Guide D7209.
1.6 The values stated in inch-pound units are to be regarded as the standard in all property and dimensional tables.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Vinyl Sheet Floor Covering Without Backing
$27.00 $54.00
Standard Test Method for Determination of Effect of Moist Heat (50% Relative Humidity and 90 degrees C) on Properties of Paper and Board
$26.00 $52.00
Standard Guide for Selection of Drilling Methods for Environmental Site Characterization
$32.00 $65.00
