ASTM D7109-12

Standard Test Method for Shear Stability of Polymer Containing Fluids Using a European Diesel Injector Apparatus at 30 and 90 Cycles

ASTM International, 11/01/2012

Publisher: ASTM

File Format: PDF

$30.00$60.00

Description

Published:01/11/2012

Pages:8

File Size:1 file , 150 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the evaluation of the shear stability of polymer-containing fluids. The test method measures the viscosity loss, in mm²/s and percent, at 100°C of polymer-containing fluids when evaluated by a diesel injector apparatus procedure that uses European diesel injector test equipment. The viscosity loss reflects polymer degradation due to shear at the nozzle. Viscosity loss is evaluated after both 30 and 90 cycles of shearing.

Note 1-This test method evaluates the shear stability of oils after both 30 and 90 cycles of shearing. For most oils, there is a correlation between results after 30 cycles and results after 90 cycles of shearing, but this is not universal.

Note 2-Test Method D6278 uses essentially the same procedure with 30 cycles only instead of both 30 and 90 cycles. The correlation between results from this test method at 30 cycles and results from Test Method D6278 has not been established.

Note 3-Test Method D2603 has been used for similar evaluation of shear stability; limitations are as indicated in the significance statement. No detailed attempt has been undertaken to correlate the results of this test method with those of the sonic shear test method.

Note 4-This test method uses test apparatus as defined in CEC L-14-A-93 . This test method differs from CEC-L-14-A-93 in the period of time required for calibration.

Note 5-Test Method D5275 also shears oils in a diesel injector apparatus but may give different results.

Note 6-This test method has different calibration and operational requirements than withdrawn Test Method D3945.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in Section 8.

More ASTM standard pdf

ASTM D6547-00(2010)

ASTM D6547-00(2010)

Standard Test Method for Corrosiveness of Lubricating Fluid to Bimetallic Couple

$26.00 $52.00

ASTM E854-14e1

Standard Test Method for Application and Analysis of Solid State Track Recorder (SSTR) Monitors for Reactor Surveillance

$33.00 $67.00

ASTM D6191-97(2014)

ASTM D6191-97(2014)

Standard Test Method for Measurement of Evolved Formaldehyde from Water Reducible Air-Dry Coatings

$27.00 $54.00

ASTM D696-98

Standard Test Method for Coefficient of Linear Thermal Expansion of Plastics Between -30 degrees C and 30 degrees C With a Vitreous Silica Dilatometer

$29.00 $58.00