Your shopping cart is empty!
ASTM International, 10/01/2021
Publisher: ASTM
File Format: PDF
$49.00$98.00
Published:01/10/2021
Pages:29
File Size:1 file , 1.1 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This test method, commonly referred to as the Cummins ISB Test, covers the utilization of a modern, 5.9'''L, diesel engine equipped with exhaust gas recirculation and is used to evaluate oil performance with regard to valve-train wear.
1.2''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1''Exceptions'''SI units are provided for all parameters except where there is no direct equivalent such as the units for screw threads, National Pipe Threads/diameters, tubing size, or where there is a sole source of supply equipment specification.
1.2.2''See also A7.1 for clarification; it does not supersede 1.2 and 1.2.1.
1.3''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See Annex A1 for general safety precautions.
1.4''Table of Contents:''
''
Section
Scope
1
Referenced Documents
2
Terminology
3
Summary of Test Method
4
Significance and Use
5
Apparatus
6
Engine Fluids and Cleaning Solvents
7
Preparation of Apparatus
8
Engine/Stand Calibration and Non-Reference Oil Tests
9
Test Procedure
10
Calculations, Ratings, and Test Validity
11
Report
12
Precision and Bias
13
Annexes
Safety Precautions
Annex A1
Intake Air Aftercooler
Annex A2
The Cummins ISB Engine Build Parts Kit
Annex A3
Sensor Locations and Special Hardware
Annex A4
External Oil System
Annex A5
Cummins Service Publications
Annex A6
Specified Units and Formats
Annex A7
Oil Analyses
Annex A8
Alternate Fuel Approval Process
Annex A9
1.5''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Nickel and Nickel-Base Alloy-Clad Steel Plate
$30.00 $60.00
Standard Test Methods for Polyurethane Raw Materials Determination of Total Chlorine in Isocyanates
$25.00 $50.00
Standard Test Method for Rate of Burning and/or Extent and Time of Burning of Plastics in a Horizontal Position
Standard Test Method for Measurement of Mass Loss and Ignitability for Screening Purposes Using a Conical Radiant Heater
$32.00 $65.00
