Your shopping cart is empty!
ASTM International, 10/01/2012
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/10/2012
Pages:5
File Size:1 file , 81 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice describes a procedure to quantify the site precision of a process analyzer via repetitive measurement of a single process sample over an extended time period. The procedure may be applied to multiple process samples to obtain site precision estimates at different property levels
1.1.1 The site precision is required for use of the statistical methodology of D6708 in establishing the correlation between analyzer results and primary test method results using Practice D7235.
1.1.2 The site precision is also required when employing the statistical methodology of D6708 to validate a process analyzer via Practices D3764 or D6122.
1.2 This practice is not applicable to in-line analyzers where the same quality control sample cannot be repetitively introduced.
1.3 This practice is meant to be applied to analyzers that measure physical properties or compositions.
1.4 This practice can be applied to any process analyzer system where the feed stream can be captured and stored in sufficient quantity with no stratification or stability concerns.
1.4.1 The captured stream sample introduction must be able to meet the process analyzer sample conditioning requirements, feed temperature and inlet pressure.
1.4.2 This practice is designed for use with samples that are single liquid phase, petroleum products whose vapor pressure, at sampling and sample storage conditions, is less than or equal to 110 kPa (16.0 psi) absolute and whose D86 final boiling point is less than or equal to 400°C (752°F).
1.5 The values for operating conditions are stated in SI units and are to be regarded as the standard. The values given in parentheses are the historical inch-pound units for information only.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Freeze/Thaw Resistance of Polymer Floor Polishes
$25.00 $50.00
Standard Test Method for Viscosity of Silicone Fluids
Standard Guide for Manual Sampling of Coal from Tops of Railroad Cars (Withdrawn 2003)
$29.00 $58.00
Standard Test Method for Determining the Dynamic Performance of a Wind Vane
$26.00 $52.00
