• Your shopping cart is empty!

  • ASTM D8111-23

ASTM D8111-23

Standard Test Method for Evaluation of Automotive Engine Oils in the Sequence IIIH, Spark-Ignition Engine

ASTM International, 03/01/2023

Publisher: ASTM

File Format: PDF

$49.00$98.00


Published:01/03/2023

Pages:40

File Size:1 file , 2.1 MB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers an engine test procedure for evaluating automotive engine oils for certain high-temperature performance characteristics, including oil thickening (as measured by kinematic viscosity increase), piston deposits, ring sticking, oil consumption, and phosphorus retention. Such oils include both single-viscosity and multiviscosity grade oils that are used in both spark-ignition, gasoline-fueled engines, as well as in diesel engines.
1.1.1 Additionally, with nonmandatory supplemental requirements, a Sequence IIIHA Test (Mini Rotary Viscometer and Cold Cranking Simulator measurements), or a Sequence IIIHB Test (phosphorus retention measurement) can be conducted. These supplemental test procedures are contained in Appendix X1 and Appendix X2, respectively.
Note 1: Companion test methods used to evaluate engine oil performance for specification requirements are discussed in SAE J304.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1 Exceptions: 
1.2.1.1 Where there is no direct SI equivalent such as screw threads, national pipe threads/diameters, tubing sizes, and valve sizes and springs.
1.2.1.2 The ring end gaps in Table A8.7, the dimensions for the blowby ventilation support bracket in Fig. A3.2, and the torque wrenches in Table A8.1 are in inch-pound units.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are provided in 6.11.6, 7.1, 7.2.1, and 7.3.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D4262-05(2018)

ASTM D4262-05(2018)

Standard Test Method for pH of Chemically Cleaned or Etched Concrete Surfaces

$21.00 $42.00

ASTM E531-76(2007)

ASTM E531-76(2007)

Standard Practice for Surveillance Testing of High-Temperature Nuclear Component Materials

$30.00 $60.00

ASTM STP 1403-01

ASTM STP 1403-01

Environmental Toxicology and Risk Assessment: Science, Policy, and Standardization-- Implications for Environmental Decisions, 10th Volume

$102.00 $204.05

ASTM D7569-10

ASTM D7569-10

Standard Practice for Determination of Gas Content of Coal-Direct Desorption Method

$32.00 $65.00