ASTM E676-02(2012)

Standard Specification for Interchangeable Taper-Ground Joints

ASTM International, 11/01/2012

Publisher: ASTM

File Format: PDF

$26.00$52.00

Description

Published:01/11/2012

Pages:4

File Size:1 file , 81 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers designations, dimensions, and tolerances for only the ground surfaces of interchangeable taper-ground joints for laboratory and industrial equipment in full-length, medium-length, short-length, and international-length (ISO K-6 series) grindings.

Note 1???The dimensions pertaining to full-length, medium-length, and short-length joints, other than for the tolerance on length of grind, were taken directly from the now obsolete Commercial Standard CS 21 .

Note 2???Tolerances on the diameters of the international-length joints do not agree with those given in ISO Recommendation R 383 . These tolerances have been established to agree with those of CS 21 in order to prevent the negative projection (large end of inner joint being smaller than large end of outer joint) permitted by ISO.

Note 3???Although glass is the most commonly used material for ground joints, other materials may be used as specified. Taper-ground joints constructed from glass should be of suitable chemical and thermal properties in accordance with Specification E438. Joints should be as free as possible of visible defects and conform to Specification E671.

1.2 The following precautionary caveat pertains only to the Test Method portion, Section 4, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D2866-11(2018)

ASTM D2866-11(2018)

Standard Test Method for Total Ash Content of Activated Carbon

$21.00 $42.00

ASTM B561-94(1999)e1

ASTM B561-94(1999)e1

Standard Specification for Refined Platinum

$25.00 $50.00

ASTM E1689-95(2008)

ASTM E1689-95(2008)

Standard Guide for Developing Conceptual Site Models for Contaminated Sites

$29.00 $58.00

ASTM C715-90(2006)

ASTM C715-90(2006)

Standard Test Method for Nickel on Steel for Porcelain Enameling by Photometric Analysis

$26.00 $52.00