Your shopping cart is empty!
ASTM International, 09/15/2012
Publisher: ASTM
File Format: PDF
$34.00$69.00
Published:15/09/2012
Pages:13
File Size:1 file , 380 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification establishes requirements for dimensions and gaging of taper pipe threads used on threaded plastic pipe and fittings.
1.2 Threads meeting this specification shall only be used on those plastic materials deemed suitable by the manufacturer.
1.3 Specialty threads or threads not requiring a leak-tight joint are not covered in this specification.
1.4 Thread DesignationsThe type of pipe threads included in this specification are designated by specifying in sequence the nominal pipe size, number of threads per inch, and the thread series symbols as follows in accordance with ANSI/ASME B 1.20.1: ³/8-18 NPT. For left-hand threads add LH to the end of the designation, otherwise right-hand threads will be understood. For example: ³/8-18 NPT-LH.
1.4.1 Each of these letters in the symbol has a definite significance as follows:
N
=
National (American Standard)
P
Pipe
T
Taper
1.5 The values stated in inch-pound units are to be regarded as the standard. No other units of measurement are included in this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see 7.2.1 and 8.3.
Standard Practice for Applied Weight Per Unit Area of Liquid Adhesive
$21.00 $42.00
Standard Test Method for Rubber Property-Volume Resistivity Of Electrically Conductive and Antistatic Products
$30.00 $60.00
Standard Practice for Testing Flake of Single-Strike Film Typewriter Ribbons
$25.00 $50.00
Standard Test Method for Density or Relative Density of Engine Coolant Concentrates and Engine Coolants By The Hydrometer
