Your shopping cart is empty!
ASTM International, 01/01/2014
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/01/2014
Pages:10
File Size:1 file , 260 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the measurement of the cut resistance of a material when mounted on a mandrel and subjected to a cutting edge under a specified load using the Cut Protection Performance (CPP) Tester.
1.1.1 This procedure is not valid for high-porosity materials which allow cutting edge contact with the mounting surface prior to cutting.
1.1.2 Test apparatus may have limitations in testing materials with a thickness greater than 3 mm or having a high frictional coefficient such as elastomers.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Ferrous Wear Debris Monitoring in In-Service Fluids Using a Particle Quantifier Instrument
$29.00 $58.00
Standard Test Method for Nanosecond Event Detection for Electrical Contacts and Connectors
$26.00 $52.00
Standard Specification for Steel Forgings, Austenitic, for Pressure and High Temperature Parts
Standard Specification for Investment Castings, Steel and Alloy, Common Requirements, for General Industrial Use
