ASTM F2510/F2510M-07(2013)

Standard Specification for Resilient Connectors Between Reinforced Concrete Manhole Structures and Corrugated High Density Polyethylene Drainage Pipes

ASTM International, 02/01/2013

Publisher: ASTM

File Format: PDF

$25.00$50.00

Description

Published:01/02/2013

Pages:3

File Size:1 file , 71 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers the design, material, and minimum performance requirements of resilient connectors used for connections between reinforced concrete structures conforming to Specifications C478 and C913 to annular corrugated profile wall high density polyethylene (HDPE) drainage pipe conforming to AASHTO M252 or Specification F2306/F2306M.

1.1.1 These connectors are designed to provide a positive seal between the pipe and manholes or other structures subjected to internal and external hydrostatic pressures less than 10.8 psi [74 KPa].

1.1.2 Testing under this standard is limited to hydrostatic pressures. Alternate air and vacuum pressure testing involve unique testing protocols and are not addressed under this standard.

1.1.3 Testing under this standard is conducted in a laboratory as a proof of design certification. Actual field performance testing would be accomplished and accepted under individual project performance standards or pipeline acceptance criteria, which is outside the scope of this standard.

Note 1-Infiltration or exfiltration quantities for an installed system are dependent upon many factors other than the connections between manhole structures and pipe, and allowable quantities must be covered by other specifications and suitable testing of the installed pipeline and system.

Note 2-This specification may be applied to other types of plastic drainage pipe. Consult with manufacturer of pipe for applicability to this standard.

1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text the SI units are shown in brackets. The values stated in each system may not be exact equivalents: therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 The following precautionary caveat pertains only to the test methods portion, Section 7. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precaution statement, see 7.2.3.

More ASTM standard pdf

ASTM D470-13

Standard Test Methods for Crosslinked Insulations and Jackets for Wire and Cable

$44.00 $89.00

ASTM C363/C363M-09(2015)

ASTM C363/C363M-09(2015)

Standard Test Method for Node Tensile Strength of Honeycomb Core Materials

$25.00 $50.00

ASTM B730-08(2013)

ASTM B730-08(2013)

Standard Specification for Welded Nickel (UNS N02200/UNS N02201) and Nickel Copper Alloy (UNS N04400) Tube

$26.00 $52.00

ASTM B226-04

Standard Specification for Cored, Annular, Concentric-Lay-Stranded Copper Conductors

$26.00 $52.00