Your shopping cart is empty!
ASTM International, 03/01/2015
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:01/03/2015
Pages:15
File Size:1 file , 220 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers requirements and test methods for the characterization of polyamide 11 pipe, tubing, and fittings for use in fuel gas pipelines. The pipe and fittings covered by this specification are intended for use in the distribution and transmission of fuel gases.
1.1.1 This specification does not cover threaded pipe. Generic fusion guidelines are given in Appendix X1. Design considerations are discussed in Appendix X2. In-plant quality control programs are specified in Annex A1.
1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 The following is an index of the annexes and appendixes in this specification:
Annexes
Subject
Annex A1
In-Plant Quality Control for sizes up to 12 in.
Annex A2
PA-11 Butt Fusion Fittings
Appendixes
Appendix X1
Butt Fusion Guidelines for PA-11 Piping
Appendix X2
Design Consideration
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1: Heat fusion joining of PA11 pipe and fittings meeting the requirements of this standard is limited to PA11 pipe and fittings meeting the requirements of this Standard. Heat Fusion joining of PA11 pipe and fittings meeting the requirements of this standard is not allowed to pipes and fittings made from any other thermoplastic materials (for example, PA12, PEs, PVCs, etc.).
Standard Specification for Plastic Insert Fittings For SDR9 Cross-linked Polyethylene (PEX) and Polyethylene of Raised Temperature (PE-RT) Tubing
$34.00 $68.00
Standard Test Method for Measurement of Airborne Sound Attenuation between Rooms in Buildings
$33.00 $67.00
Standard Practice for Sampling Industrial Chemicals
$46.00 $92.00
Standard Practice for Ultrasonic Examination from Bored Surfaces of Cylindrical Forgings
$26.00 $52.00
