Your shopping cart is empty!
ASTM International, 07/01/2014
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:01/07/2014
Pages:16
File Size:1 file , 570 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover establishment of procedures for conducting tests to determine the mechanical properties of externally and internally threaded fasteners, washers, direct tension indicators, and rivets.
1.2 Property requirements and the applicable tests for their determination are specified in individual product standards. In those instances where the testing requirements are unique or at variance with these standard procedures, the product standard shall specify the controlling testing requirements. In the absence of any specified test requirement(s), these test methods shall apply.
1.3 These test methods describe mechanical tests for determining the following properties:
Section
For Externally Threaded Fasteners:
3
Product Hardness
3.1
Proof Load
3.2.1
Method 1, Length Measurement
3.2.3
Method 2, Yield Strength
3.2.4
Method 3, Uniform Hardness
3.2.5
Axial Tension Testing of Full-Size Product
3.4
Wedge Tension Testing of Full-Size Product
3.5
Tension Testing of Machined Test Specimens
3.6
Total Extension at Fracture Test Single Sheer Test
3.7 3.8
For Internally Threaded Fasteners:
4
4.1
Proof Load Test
4.2
Cone Proof Load Test
4.3
For Washers and Direct Tension Indicators:
5
Product Hardness-General Requirements
5.1
Through Hardened Washers
5.2
Carburized Washers
5.3
Stainless Steel and Nonferrous Washers
5.4
Direct Tension Indicators
5.5
Compression Load
5.6
For Rivets:
6
6.1
Test for Embrittlement of Metallic-Coated Externally Threaded Fasteners
7
Test Method for Determining Decarburization and Carburization
8
1.4 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
Note 1: A complete metric companion to Test Methods F606 has been developed-F606M; therefore, no metric equivalents are shown in these test methods.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Deformed and Plain Stainless-Steel Bars for Concrete Reinforcement
$32.00 $65.00
Standard Specification for Forged or Rolled Alloy and Stainless Steel Pipe Flanges, Forged Fittings, and Valves and Parts for High-Temperature Service
$33.00 $67.00
Standard Test Method for Speciated Organic Volatile Content of Waterborne Multi-Component Coatings by Gas Chromatography
$24.00 $48.00
Standard Specification for Factory-Made Wrought Nickel and Nickel Alloy Fittings
$29.00 $58.00
