Your shopping cart is empty!
ASTM International, 01/01/2013
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:01/01/2013
Pages:12
File Size:1 file , 170 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This guide is intended for use in the selection, design, and installation of thermoplastic water systems for use outside buildings. For specific projects, a thorough review of this guide is recommended for the purpose of selecting specific materials, methods of joining, system design factor, and any special procedures deemed necessary to assure a satisfactory system.
1.2 It is recommended that governing codes and project specifications be consulted prior to the use of this guide. Nothing in this guide should be construed as recommending practices or systems at variance with governing codes and project specifications.
1.3 Units-The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The pipe, fittings, and joining materials shall meet the requirements of one or more of the following component product standards listed in 1.3.1 through 1.3.3 to the extent applicable. Those pipe standards followed by (a) are outside diameter-controlled pipes. Those followed by ( b) are inside diameter-controlled pipes.
1.3.1 For poly(vinyl chloride) (PVC) plastic piping components:
Title of Specification
ASTM Designation
Poly(Vinyl Chloride) (PVC) Plastic Pipe, Schedules 40, 80 and 120 (a)
D1785
Poly(Vinyl Chloride) (PVC) Plastic Pipe (SDR-PR) (a)
D2241
Threaded Poly(Vinyl Chloride) (PVC) Plastic Pipe Fittings, Schedule 80
D2464
Poly(Vinyl Chloride) (PVC) Plastic Pipe Fittings, Schedule 40
D2466
Socket-Type Poly(Vinyl Chloride) (PVC) Plastic Pipe Fittings, Schedule 80
D2467
Solvent Cements for Poly(Vinyl Chloride) (PVC) Plastic Pipe and Fittings
D2564
Bell-End Poly(Vinyl Chloride) (PVC) Pipe (a)
D2672
Poly(Vinyl Chloride) (PVC) Plastic Tubing (a)
D2740
Socket-Type Poly(Vinyl Chloride) (PVC) Plastic Line Couplings
D3036
Joints for Plastic Pressure Pipes Using Flexible Elastomeric Seals
D3139
Elastomeric Seals (Gaskets) for Joining Plastic Pipe
F477
PVC and ABS Injected Solvent Cemented Plastic Pipe Joints
F545
1.3.2 For polyethylene (PE) plastic piping components:
Polyethylene (PE) Plastic Pipe, (SDR-PR) (b)
D2239
Plastic Insert Fittings for Polyethylene (PE) Plastic Pipe
D2609
Socket-Type Polyethylene Fittings for Outside Diameter- Controlled Polyethylene Pipe ( a)
D2683
Polyethylene (PE) Plastic
Standard Specification for Heat Resistant Aluminum-Zirconium Alloy Wire for Electrical Purposes
$26.00 $52.00
Standard Guide for Silver-Tin Oxide Contact Material
Standard Test Method for Critical Radiant Flux of Floor-Covering Systems Using a Radiant Heat Energy Source
$33.00 $67.00
Standard Test Methods for Rosin Acids Content of Pine Chemicals, Including Rosin, Tall Oil, and Related Products
