Your shopping cart is empty!
ASTM International, 09/10/1996
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:10/09/1996
Pages:5
File Size:1 file , 99 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers plastic insert fittings for polybutylene (PB) plastic tubing. These fittings are intended for use in 100-psi (6.9-MPa) cold- and hot-water distribution systems operating at temperatures up to and including 180°F (82°C). Included are the requirements for materials, workmanship, burst pressure, sustained pressure, temperature cycling tests, and markings to be used on the fittings.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI values stated in parentheses are provided for information purposes.
1.3 The following safety hazards caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Sonic Velocity in Manufactured Carbon and Graphite Materials for Use in Obtaining an Approximate Value of Young's Modulus
$31.00 $62.00
Standard Specification for Carbon and Low-Alloy Steel Forgings, Requiring Notch Toughness Testing for Piping Components
$30.00 $60.00
Standard Specification for Seamless, Welded, and Heavily Cold Worked Austenitic Stainless Steel Pipes
$33.00 $67.00
Standard Specification for Titanium and Titanium Alloy Welded Pipe
$29.00 $58.00