Your shopping cart is empty!
ASTM International, 03/01/2013
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/03/2013
Pages:5
File Size:1 file , 85 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural bolt.
1.2 Two types of direct tension indicators in nominal diameter sizes M16 through M36 are covered:
1.2.1 Type 8.8-direct tension indicators for use with Specification A325M bolts, and
1.2.2 Type 10.9-direct tension indicators for use with Specification A490M bolts.
1.3 Direct tension indicators are intended for installation under either a bolt head or a hardened washer. (See Research Council on Structural Connections: Specification for Structural Joints Using ASTM A325 or A490 Bolts.)
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 The following precautionary statement pertains only to the test methods portions, Section 12, and Appendix X1 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Methods for Magnet-Wire Enamels
$30.00 $60.00
Standard Test Method for Relative Resistance to Vented Water-Tree Growth in Solid Dielectric Insulating Materials
$24.00 $48.00
Standard Test Methods for Determining Dispersive Characteristics of Clayey Soils by the Crumb Test
$25.00 $50.00
Standard Specification for Gas Turbine Fuel Oils
